Performance Specifications
Performance Specifications
Table 1. Electrical Performance
Parameter
Symbol
Min
Typical
Maximum
Units
Supply
Voltage1, 5V option
3.3V option
Current2, 5V option
3.3V option
VDD
IDD
4.750
3.135
5.0
3.3
5.250
3.465
V
55
40
mA
Frequency
Nominal Frequency3
Pull Range2,6, ordering option
Linearity2
Gain Transfer2, 61.440MHz
30.720MHz
fN
APR
Lin
KV
1.544
77.760
MHz
ppm
%
50, 80, 100
5
+80
+120
ppm/V
Temperature Stability
fSTAB
20
ppm
V
Outputs
Output Logic Levels2
Output Logic High
Output Logic Low
VOH
VOL
0.9*VDD
0.1*VDD
Load
Rise Time2,4
IOUT
tR
15
5
pF
ns
Fall Time2,4
tF
5
ns
Symmetry2
Period Jitter5,7, RMS (61.44 MHz)
Period Jitter5,7, Peak - Peak (61.44MHz)
SYM
фJ
45
50
3.0
23
55
%
ps
фJ
ps
Phase Noise8
10Hz
100Hz
dBc/Hz
-63
-97
1kHz
10kHz
100kHz
1MHz
10MHz
-129
-144
-157
-159
-164
Control Voltage
Control Voltage Range for Pull Range
VC
ZIN
0.5
0.3
4.5
3.0
V
Control Voltage Input Impedance
“E”Ordering Option, +3.3V only
100
KΩ
Mꢀ
2
Control Voltage Modulation BW
Output Enable/Disable9
Output Enabled
BW
10
kHz
V
VIH
VIL
0.9*VDD
Output Disabled
0.1*VDD
10
Start-Up Time
TSU
TOP
ms
°C
Operating Temp, Ordering Option
Package Size
0/70 or -40/85
5.0 x 3.2 x 1.2
mm
1] The power supply should have by-pass capacitors as close to the supply and to ground as possible, for examples 0.1 and 0.01uF
2] Parameters are tested with production test circuit in Figure 1.
3] See Standard Frequencies and Ordering Information tables for more specific information
4] Measured from 20% to 80% of a full output swing (Fig 2).
5] Not tested in production, guaranteed by design, verified at qualification.
6] Tested with Vc = 0.3V to 3.0V unless otherwise stated in part description
7] Broadband Period Jitter measured using Wavecrest SIA3300C, 90K samples.
8] Phase Noise is measured with an Agilent E5052A.
9] The Output is Enabled if the Enable/Disable is left open.
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Page2
