AZ991
MINIATURE PC
BOARD RELAY
FEATURES
• Contacts rated at 3, 5 or 10 Amps
• Meets FCC Part 68.302 1500 lightning surge
• Meets FCC Part 68.304 1000 V dielectric
• 0.240" (6.1 mm) min. between coil and contact
• Low cost
• DC coils to 48 VDC
• Flux-tight available
• UL, CUR file E44211
GENERAL DATA
Life Expectancy
Mechanical
Electrical
Minimum operations
1 x 107
1 x 105 at 10 A 120 VAC Res.
CONTACTS
Arrangement
SPDT (1 Form C)
(Form A available on request)
Operate Time (typical) 6 ms at nominal coil voltage
Release Time (typical) 2 ms at nominal coil voltage
Ratings
Resistive load:
Dielectric Strength
(at sea level for 1 min.) 750 Vrms across contacts
Meets FCC Part 68.302 lightning surge
2500 Vrms contact to coil
Light Duty Max. switched power: 90 W or 831 VA
Max. switched current: 3 A
Max. switched voltage: 30 VDC or 277 VAC
UL Rating: 3 A at 30 VDC or 277 VAC
Meets FCC Part 68.304 1000 V dielectric
Insulation Resistance 100 megohms min. at 500 VDC, 20°C
Medium Duty Max. switched power: 150 W or 1250 VA
Max. switched current: 5 A
50% RH
Max. switched voltage: 30 VDC or 277 VAC
UL Rating: 5 A at 30 VDC or 277 VAC
1/10 HP 277 VAC
Dropout
Greater than 10% of nominal coil voltage
Ambient Temperature
Operating
-40°C (-13°F) to 70°C (158°F)
-55°C (-67°F) to 105°C (221°F)
Heavy Duty Max. switched power: 300 W or 1250 VA
Max. switched current: 10 A
Storage
Max. switched voltage: 30 VDC or 125 VAC
UL Rating: 5 A at 30 VDC or 10 A 125 VAC
Vibration
0.062" DA at 10–55 Hz
10 g
Shock
Material
Silver cadmium oxide
< 100 milliohms initially
Enclosure
P.B.T. polyester
Tinned copper alloy, P.C.
270°C (500°F)
5 seconds
Resistance
Terminals
COIL
Max. Solder Temp.
Max. Solder Time
Max. Solvent Temp.
Power
At Pickup Voltage
(typical)
256 mW
80°C (176°F)
Max. Immersion Time 30 seconds
Max. Continuous
Dissipation
1.1 W at 20°C (68°F) ambient
0.86 W at 40°C (104°F) ambient
Weight
10 grams
Temperature Rise
Temperature
30°C (54°F) at nominal coil voltage
Max. 105°C (267°F)
NOTES
1. All values at 20°C (68°F).
2. Relay may pull in with less than “Must Operate” value.
3. Unsealed version available upon request.
4. Tape should be pulled off after wave solder and cleaning.
5. Specifications subject to change without notice.
12/15/03W
